What it means
dE on a Thermador range means the cooktop is in demo mode, so the zones do not heat. Trip the circuit breaker for 30 seconds, restore it, and touch any control within 3 minutes.
Thermador range dE / Modes and limits
dE on a Thermador range means the cooktop is in demo mode, so the zones do not heat. Trip the circuit breaker for 30 seconds, restore it, and touch any control within 3 minutes.
Also appears as dE
dE on a Thermador range means the cooktop is in demo mode, so the zones do not heat. Trip the circuit breaker for 30 seconds, restore it, and touch any control within 3 minutes.
It is in the electrical panel.
dE returns after the reset.
Your Thermador steps, stored on this device only

It is in the electrical panel.

Then switch it on again.

You have 3 minutes after power returns.
If it heats, demo mode is off.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Demo mode is on. The ranges page files it under cooking zones that do not heat up.
Read the supporting manualThe entry speaks only of the cooking zones.
Read the supporting manualNo. The breaker is in your panel and the reset is a switch off and on.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "dE and cooking zones do not heat up"
Source: the ranges page of Thermador's oven support section, entry dE.
That is how the display prints demo mode, with a small d and a capital E. It is not a typo.
Thermador's entry does not say whether the oven works while dE shows. It describes the cooktop zones staying cold.
Repeat the reset once, then book a visit.
No, switching a breaker is an ordinary reset and the entry describes it as the fix. Keep it off for 30 seconds.
Thermador messages, symptoms, parts, repair visits
On a Thermador Pro range, each rangetop burner has its own igniter and should catch within four seconds. If one will not, Thermador’s first suspect is a burner cap sitting out of alignment. Reseat it, dry everything, and check the knob. Several burners dead, or sparking that never stops, needs a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.