What it means
ERROR on a Thermador MicroDrawer means the sensor could not detect vapor properly while cooking. Touch stop/clear and cook manually, checking the food temperature afterwards.
Thermador microwave ERROR / Modes and messages
ERROR on a Thermador MicroDrawer means the sensor could not detect vapor properly while cooking. Touch stop/clear and cook manually, checking the food temperature afterwards.
Also appears as ERROR
ERROR on a Thermador MicroDrawer means the sensor could not detect vapor properly while cooking. Touch stop/clear and cook manually, checking the food temperature afterwards.
This clears the message.
ERROR appears on sensor cooking for several foods.
Your Thermador steps, stored on this device only

This clears the message.

Set a manual time and power level.

Measure the temperature after cooking; add time if needed.

Wait two minutes after plugging in before using sensor settings.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The sensor did not detect vapor properly. Popcorn is excepted.
Read the supporting manualThe guide advises wiping moisture off the outside of the container and the cavity first.
Read the supporting manualNot by this message alone.
Read the supporting manualWhile the food name shows on the display, the sensor is measuring vapor. Opening the drawer or touching stop/clear during that part interrupts the measurement and an error message appears. To continue, touch stop/clear and cook manually.
Read the supporting manualManufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 30.09.2025; file tag _B (no printed edition date read) / PDF p13
Source: the use and care guide for the Thermador MicroDrawer microwave ovens MD24BS and MD30BS, p. 13.
The guide excepts popcorn from this message. For sensor cooking of other foods, ERROR means the sensor could not detect vapor properly.
Yes, manually. Touch stop/clear, then set a time and power level yourself and measure the food temperature afterwards.
The guide says to wait two minutes after plugging the appliance in before using the sensor settings, and gives no reason beyond that.
Book a visit if ERROR appears on sensor cooking for many foods. First wipe moisture off the container and the cavity, as the guide advises.
Yes, during the first part of a sensor cycle, while the food name is on the display. After vapor has been detected, opening the drawer only pauses the cycle.
Thermador messages, symptoms, parts, repair visits
When a Thermador built-in microwave’s display works but the oven will not run, the guide asks you to confirm the door is shut with nothing caught in the seal, the door is undamaged and demo mode is off. A fully dead display points to the breaker, fuse or plug.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.