What it means
ENJOY YOUR MICROWAVE TOUCH CLEAR flashes on a Thermador MicroDrawer after the power was interrupted, and your settings are gone. Press the stop/clear key and set the clock again.
Thermador microwave ENJOY YOUR MICROWAVE TOUCH CLEAR / Modes and messages
ENJOY YOUR MICROWAVE TOUCH CLEAR flashes on a Thermador MicroDrawer after the power was interrupted, and your settings are gone. Press the stop/clear key and set the clock again.
Also appears as ENJOY YOUR MICROWAVE TOUCH CLEAR
ENJOY YOUR MICROWAVE TOUCH CLEAR flashes on a Thermador MicroDrawer after the power was interrupted, and your settings are gone. Press the stop/clear key and set the clock again.
The guide says to simply press it.
The prompt appears with no power cut beforehand.
Your Thermador steps, stored on this device only

The guide says to simply press it.

Press timer/settings and set the time again.

If the power cut happened during cooking, the program stops; judge the food before eating it.

If the prompt appears with no power cut, book a visit.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
After a mains power interruption the display shows it intermittently once power returns.
Read the supporting manualNo. The guide says current settings are erased.
Read the supporting manualNo, it follows a power cut.
Read the supporting manualManufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 30.09.2025; file tag _B (no printed edition date read) / PDF p18
Source: the use and care guide for the Thermador MicroDrawer microwave ovens MD24BS and MD30BS, pp. 18 and 38.
The guide cautions against leaving food in for more than one hour before or after cooking.
Not after a power cut. The prompt follows a mains power interruption, so press stop/clear and set the clock again; call only if it appears with no power cut.
Press stop/clear to clear the prompt, then press timer/settings and follow the display to set the time again.
Book a visit if the prompt repeats with no power cut beforehand. After a power cut it is only a prompt, not a failure.
Thermador messages, symptoms, parts, repair visits
When a Thermador built-in microwave’s display works but the oven will not run, the guide asks you to confirm the door is shut with nothing caught in the seal, the door is undamaged and demo mode is off. A fully dead display points to the breaker, fuse or plug.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.