What it means
E7010 means a Thermador cooktop cannot reach your home Wi-Fi network or the hood. Switch the cooktop off and on again; a one-off message disappears by itself.
Thermador cooktop E7010 / Connection
E7010 means a Thermador cooktop cannot reach your home Wi-Fi network or the hood. Switch the cooktop off and on again; a one-off message disappears by itself.
Also appears as E7010
E7010 means a Thermador cooktop cannot reach your home Wi-Fi network or the hood. Switch the cooktop off and on again; a one-off message disappears by itself.
If the cooktop is paired with a hood, make sure the hood has power.
E7010 returns after the restart.
Your Thermador steps, stored on this device only

If the cooktop is paired with a hood, make sure the hood has power.

Confirm your router is on and the network is up.

The Thermador manual's only step is to turn the appliance off and on again.

If E7010 comes back, book a visit and mention the router and hood setup.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
A connection problem: the cooktop is unable to connect to your home network or to the hood. It does not affect the cooking zones in the Thermador manual's wording.
Read the supporting manualNo. The supply messages are E9000, E9010 and E9011; E7010 concerns connectivity only.
Read the supporting manualThe manual says a one-off occurrence disappears after restarting. A repeat is the reason to ask for help.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E7010"
Source: the error-code page for Thermador induction cooktops; E7010 also appears on the ranges page.
The source mentions the home network and the hood, not an app.
The Thermador manual does not say it blocks cooking. Restart and see.
The hood is one of two named links, so a hood without power may be involved.
Your router setup and whether the hood is installed.
Thermador messages, symptoms, parts, repair visits
When one Thermador burner will not light while the rest do, the support page points to the burner cap: it is out of alignment, and its tabs must sit in the notches on the burner base. The cooktop guide adds a 4-second rule and clean, dry igniter ports. Gas odor means shut the unit off and book a visit.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.