What it means
The machine has become too hot, and the Thermador manual tells you to switch it off for 30 minutes so it can cool. Use it again after that.
Thermador coffee machine LEAVE DEVICE TO COOL / Messages
The machine has become too hot, and the Thermador manual tells you to switch it off for 30 minutes so it can cool. Use it again after that.
Also appears as LEAVE DEVICE TO COOL
The machine has become too hot, and the Thermador manual tells you to switch it off for 30 minutes so it can cool. Use it again after that.
Turn the machine off and leave it alone.
The message returns after cooling.
Your Thermador steps, stored on this device only

Turn the machine off and leave it alone.

The Thermador manual gives exactly that time.

Start it once the half hour is up and watch the display.

A message that comes straight back after a full cooldown calls for a technician.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The machine has overheated. The Thermador manual asks for half an hour switched off.
Read the supporting manualNo. The two share one troubleshooting entry, but this one concerns heat and the other concerns supply voltage.
Read the supporting manualA separate message, SWITCH OFF WITH POWER SWITCH AND THEN BACK ON AFTER 30 SEC!, lists a warm machine and a dirty brewing unit as causes. This one lists only cooling.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "Coffee Machine Components"
Manufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 15.02.2022; file tag _A (no printed edition date read) / PDF p36
Source: the Thermador coffee machine troubleshooting page and the TCM24PS guide p36; no other detail is printed.
Switch the machine off for 30 minutes so it can cool. After that you can use it again.
No. The instruction is to switch the machine off.
The source does not say so; it asks for a cooldown.
Repeated overheating after a full 30-minute rest is not explained by the sources, so book a visit.
Thermador messages, symptoms, parts, repair visits
A Thermador built-in coffee machine that gives thin froth or takes in no milk usually has limescale, a blocked outlet or suction pipe, unsuitable milk or badly assembled milk parts. Run the descaling program, clean the outlet and tubes, use cold milk with at least 1.5% fat and reassemble the parts wet.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.