Start from the symptom
Thermador coffee machine milk froth problems.
A Thermador built-in coffee machine that gives thin froth or takes in no milk usually has limescale, a blocked outlet or suction pipe, unsuitable milk or badly assembled milk parts. Run the descaling program, clean the outlet and tubes, use cold milk with at least 1.5% fat and reassemble the parts wet.

Start with safe observations.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Descale
Limescale in the appliance is a listed cause. Run the descaling program.
- 2
Clean the outlet
The beverage outlet or one of its 3 connections can be blocked. Clean the outlet and connections.
- 3
Check the milk
Always use cold milk with a fat content of at least 1.5%. Milk that is not suitable will not foam.
- 4
Reassemble
If the outlet or milk tubes are not properly assembled, moisten the parts and put them together again.
- 5
Suction pipe
A blocked suction pipe needs cleaning. The manual has the steps.
- 6
Milk tube
If hot water tastes of milk, the milk tube has not been removed from the container.
Systems a technician may investigate.
These parts relate to the symptom, though what you noticed cannot show that any single one has failed.
If the display adds a code.
When observation becomes a service request.
Leave internal testing to a technician.
Froth stays poor after descaling and cleaning.
The machine shows Clean brewing unit or a descaling overdue message.
Milk sprays or the quality fluctuates after all parts were cleaned.
The nozzle stays blocked after cleaning.
Arrange a diagnosticSources and model boundaries.
These documents back up the Thermador coffee machine milk froth problems guidance. Choose the manual written for your model.
- Troubleshooting | Coffee Machines Support | Thermador
Match your model to the guide it shipped with. See how we research these pages.
What milk should I use?
Cold milk with a fat content of at least 1.5%.
Why does the froth quality change?
Limescale or a blocked suction pipe. Descale and clean the pipe.
The hot water or steam will not come out.
The nozzle may be blocked. Unscrew it counterclockwise, clear the airway gently, rinse with hot water and refit.
Is whistling while dispensing hot water a problem?
No. Thermador says it is normal.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
Descaling program is overdue. Device will shortly be locked.
The machine says descaling is overdue and it will shortly be locked. Run the descaling program now; the TCM24PS guide says a locked machine works again only after descaling has been carried out.
Thermador coffee machine milk froth problems
A Thermador built-in coffee machine that gives thin froth or takes in no milk usually has limescale, a blocked outlet or suction pipe, unsuitable milk or badly assembled milk parts. Run the descaling program, clean the outlet and tubes, use cold milk with at least 1.5% fat and reassemble the parts wet.
Coffee machine milk system
The milk system on a Thermador coffee machine draws milk through tubes into a beverage outlet. MILK CONTAINER CONNECTED? can show even when the container is on, if it sits outside the sensor range. The system needs rinsing and a weekly soapy clean.
Coffee machine repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.

