Start from the symptom
Thermador ice maker not working.
When a Thermador fridge-freezer makes no ice at all, the guide lists four causes: ice production is switched off, no water reaches the unit, the hose is kinked, or the ice maker itself has an error. Turn production on, open the valve, straighten the hose and run the 5-minute power reset.

Start with safe observations.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Is production on
Ice cube production can be switched off in the controls. Switch it on.
- 2
Water supply
Make sure water is being supplied and the shut-off valve on the water connection is open. Call an installer if needed.
- 3
Kinked hose
Turn the water off and work any kink out of the hose. A damaged hose should be replaced.
- 4
Power reset
If the ice maker itself has failed, switch the appliance off, unplug it or trip the breaker, wait 5 minutes and reconnect.
- 5
Fill level sensor
Food or objects in the ice container can block the fill level sensor. Remove everything but ice.
Systems a technician may investigate.
These parts relate to the symptom, though what you noticed cannot show that any single one has failed.
If the display adds a code.
Look after it the way this appliance's own guide describes.
When observation becomes a service request.
Leave internal testing to a technician.
Production is on, water is flowing and the power reset did not help.
The refrigerator shows an ice maker error.
Water leaks near the ice maker.
You are unsure about the water connection.
Arrange a diagnosticSources and model boundaries.
These documents back up the Thermador ice maker not working guidance. Choose the manual written for your model.
- Use and care guide, Fridge-freezer combination T36BT110NS T36BT120NS T36IT100NP (en-us)
Match your model to the guide it shipped with. See how we research these pages.
How do I reset the ice maker?
Switch off the appliance, disconnect it from power, wait 5 minutes, reconnect it and switch on. If it persists, call service.
Could my hose be the problem?
Yes. A kink stops water. Straighten it, or replace the hose if damaged.
Does the ice container matter?
Food or objects in it can block the fill level sensor.
Is it safe to check the valve?
Yes, make sure it is open. Ask an installer if you are unsure about the connection.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
Fault in the ice maker
"Fault in the ice maker" is a cause the Thermador fridge-freezer guide lists for low ice production. Switch the appliance off, disconnect power, reconnect after 5 minutes, and get service if it persists.
Thermador ice maker not working
When a Thermador fridge-freezer makes no ice at all, the guide lists four causes: ice production is switched off, no water reaches the unit, the hose is kinked, or the ice maker itself has an error. Turn production on, open the valve, straighten the hose and run the 5-minute power reset.
Ice maker fill level sensor
The fill level sensor tells a Thermador ice maker when the ice storage container is full. The fridge-freezer guide lists food or objects blocking it as a cause of low ice. Remove everything from the container; the guide says never to store food in it.
Ice maker repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.
