What it means
"Fault in the ice maker" is a cause the Thermador fridge-freezer guide lists for low ice production. Switch the appliance off, disconnect power, reconnect after 5 minutes, and get service if it persists.
Thermador refrigerator Fault in the ice maker / Ice and water
"Fault in the ice maker" is a cause the Thermador fridge-freezer guide lists for low ice production. Switch the appliance off, disconnect power, reconnect after 5 minutes, and get service if it persists.
Also appears as Fault in the ice maker
"Fault in the ice maker" is a cause the Thermador fridge-freezer guide lists for low ice production. Switch the appliance off, disconnect power, reconnect after 5 minutes, and get service if it persists.
The guide first lists food or objects blocking the ice maker's fill level sensor; empty the ice storage container.
Ice production stays low after the 5-minute power cycle.
Your Thermador steps, stored on this device only

The guide first lists food or objects blocking the ice maker's fill level sensor; empty the ice storage container.

Unplug the appliance or switch off its breaker.

Then reconnect.

Low ice that stays low after the power cycle needs a technician.
Give us your model number and the checks you already made, then start your request below.
Book a visit
A simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The troubleshooting table, under low ice production. The table lists blocked sensor first and the ice maker line second.
Read the supporting manualRemove everything from the ice storage container, because objects can block the fill level sensor.
Read the supporting manualNo. It is a cause in a table.
Read the supporting manualManufacturer document
BSH Home Appliances Corporation (Thermador US manual PDF, media3.bsh-group.com)
PDF created 05.06.2026; file tag _F (no printed edition date read) / PDF p42
Source: the use and care guide for the Thermador fridge-freezer combinations T36BT110NS, T36BT120NS and T36IT100NP, p. 42.
The guide gives a blocked sensor or an ice maker problem; it names no other reason.
Wait 5 minutes between disconnecting the power and reconnecting it, as the guide says.
It has its own symbol, flashing when the filter is old.
Get service if ice production stays low after the 5-minute power reset.
Thermador messages, symptoms, parts, repair visits
A flashing Water Filter symbol on a Thermador refrigerator means the water filter is old and needs replacing. Replace the filter, then reset the symbol.
A Thermador fridge-freezer with lights on but no cooling may be in showroom (demo) mode. Otherwise the guide calls frequent running normal, blames covered vents, and suggests a 5-minute power-down when readings stray from the setting. Try those, then book a technician.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.