Start from the symptom
Thermador ice maker low ice production.
Low ice from a Thermador fridge-freezer is often just timing or supply: the unit was recently connected, the freezer was opened a lot, water pressure is low, or the filter is blocked. Wait about 4 hours after connecting, then check pressure and the filter and clear the ice container.

Start with safe observations.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
New connection
If the appliance was only recently connected, wait about 4 hours for the first batch.
- 2
Freezer openings
Frequent or long door openings slow production. Check again after a few hours.
- 3
Water pressure
Low pressure in the supply or an external filter system such as reverse osmosis reduces output. Connect only to a supply with enough pressure.
- 4
Water filter
A blocked filter cuts supply. Change it.
- 5
Sensor
Food or objects can block the fill level sensor for the ice maker. Remove everything from the storage container.
Systems a technician may investigate.
These parts relate to the symptom, though what you noticed cannot show that any single one has failed.

Ice maker fill level sensor
The fill level sensor tells a Thermador ice maker when the ice storage container is full. The fridge-freezer guide lists food or objects blocking it as a cause of low ice. Remove everything from the container; the guide says never to store food in it.

Refrigerator water filter
A Thermador refrigerator's water filter cleans water for the dispenser and for ice. The fridge-freezer guide says to change it every 6 months, when Filter is expired lights, or when water or ice output drops. Discard the first 24 hours of ice after a change.
If the display adds a code.
Look after it the way this appliance's own guide describes.
When observation becomes a service request.
Leave internal testing to a technician.
Production stays low after the filter was changed and pressure checked.
The ice maker shows an error.
You cannot measure the supply pressure.
Ice stops entirely.
Arrange a diagnosticSources and model boundaries.
These documents back up the Thermador ice maker low ice production guidance. Choose the manual written for your model.
- Use and care guide, Fridge-freezer combination T36BT110NS T36BT120NS T36IT100NP (en-us)
Match your model to the guide it shipped with. See how we research these pages.
How long until the first ice?
About 4 hours after the appliance was connected.
Does the filter matter?
Yes. A blocked water filter is a listed cause of low production.
What is the fill level sensor?
It checks the ice storage level. Food or objects in the container can block it.
What if I use reverse osmosis?
Check the pressure of the external filter system. Low pressure reduces output.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
Fault in the ice maker
"Fault in the ice maker" is a cause the Thermador fridge-freezer guide lists for low ice production. Switch the appliance off, disconnect power, reconnect after 5 minutes, and get service if it persists.
Thermador ice maker not working
When a Thermador fridge-freezer makes no ice at all, the guide lists four causes: ice production is switched off, no water reaches the unit, the hose is kinked, or the ice maker itself has an error. Turn production on, open the valve, straighten the hose and run the 5-minute power reset.
Refrigerator water filter
A Thermador refrigerator's water filter cleans water for the dispenser and for ice. The fridge-freezer guide says to change it every 6 months, when Filter is expired lights, or when water or ice output drops. Discard the first 24 hours of ice after a change.
Ice maker repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.