Maintenance

A tank that must be emptied every time plus a descaling program that cannot be cut short

After every steam session empty and dry the water tank and leave the door open until the cavity cools. Run Descaling when the oven asks, mixing 3.5 cups of water with half a bottle of descaler. It lasts about 70 to 90 minutes. Run Ecolytic Clean when dark patches appear. [1][2]

A hand slides a clear water tank out of a steam oven's side, with a folded cloth and a cup of pale liquid nearby.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • The cavity can rust if it is not cared for after every use. 2
  • Fresh tap water or plain non-carbonated purchased water only; never distilled water. 2
  • Descaling mixes 3.5 cups of water with half a bottle (200 ml) of descaler, and the rinse cycles are part of it. 2
  • Do not use steel wool, abrasive pads, chlorine cleaners or cellulose sponges. 2

What should I do after every steam session?#

Let the cavity cool with the door at rest, empty and dry the water tank, then wipe food residue and spills from the cavity with the cleaning sponge once it is cool and dry it with a soft cloth. The cavity can rust if neglected. 2

Thermador's manual says to carry these out after every use. 2 Notes that explain why: burned-on residue is very difficult to remove later, and salts are very abrasive and can cause rust spots. 2 Stand beside the oven when you open the door, crack it slowly and keep your face out of the opening so hot air and steam can escape. 2

How do I empty and dry the water tank?#

Open the door, slide the tank out while holding it level so nothing drips down through the vent, pour out the water, dry the lid seal and the tank slot, and leave the tank to dry with the lid open. 2

  1. 1

    Let the door rest open#

    Leave the oven door open in the at-rest position until the cavity has cooled down. 2

    A built-in steam oven with its door resting open at an angle and wisps of steam drifting out above it.
  2. 2

    Pull the tank out level#

    Keep it level as you slowly pull it out so that remaining water does not drip out through the vent. 2

    A hand slides a clear water tank, half full, out of the right side of an open steam oven.
  3. 3

    Pour it out and dry the seal and slot#

    Thoroughly dry the seal of the tank lid and the slot where the tank sits. 2

  4. 4

    Let it air with the lid open#

    Prolonged dampness can lead to a musty odor in the tank. Close the lid and reinstall it empty afterward. 2

    A clear water tank with its lid open stands upright on a striped dish towel to air dry.

The tank is not dishwasher safe. Clean it with a soft cloth and washing-up liquid. 2 Moisten the seal in the lid with a little water before first use. 2

What water can I put in the tank?#

Only fresh tap water or plain non-carbonated purchased water. Distilled water and other liquids can damage the oven. A very hard supply, 10 grains per gallon or more, calls for softened water, Thermador says. 2

For highly chlorinated tap water, above 4 mg/L, the manual says to use plain non-carbonated purchased water with a low amount of chlorine. 2 Descaling uses its own descaling solution, which belongs in the tank only for that program. 2

How do I set the water hardness?#

Measure your water with a hardness test strip or ask the water utility, then in the settings touch Water Hardness and swipe to the matching level. The setting makes the oven remind you when to descale. 2

The manual says to reset it if you move or if your water source changes. 2 Without the right level, the reminder arrives too early or too late, and the oven's descale interval is only as good as that number.

How do I run the Descaling program?#

Mix 3.5 cups (800 ml) of water with half a bottle (200 ml) of descaler, start Descaling from the menu, put the mixture in the tank and follow the display through the first and second rinse cycles. Expect 70 to 90 minutes. 2

  1. 1

    Prepare the solution#

    Mix 3.5 cups (800 ml) of water with half a bottle (200 ml) of descaler and set it aside. Follow the dilution on the descaler packaging. 12

    A hand pours pale liquid from a glass measuring cup into a clear water tank held in the other hand.
  2. 2

    Open Descaling#

    Press ON/OFF, press MENU, swipe to Descaling, touch Continue twice. 2

  3. 3

    Fill the tank with the solution#

    Remove the tank, fill it with the prepared solution, insert it and press START/STOP. The duration shows and cannot be changed. 2

  4. 4

    Run the first rinse#

    When the display asks, open the door, rinse the tank, fill it with fresh water and close the door. A signal sounds at the end. 2

  5. 5

    Run the second rinse and finish#

    Repeat once more. Then empty, rinse and dry the tank and reinsert it. The oven is ready. 2

For hygiene reasons the program must run all the way through. 2 If the solution touches the control panel or other delicate surfaces, it will damage them, so rinse it off with water immediately. 2 Limescale in the cavity is the same cure: run the DESCALE program. 1

When should I use Ecolytic Clean?#

When the self-cleaning surfaces show dark patches, or when the oven recommends cleaning on its display. The cycle takes 1 hour and starts from MENU with the cavity emptied of racks, rails and accessories. 12

The side, ceiling and back panels carry a porous, matte ceramic coating that absorbs and breaks down splashes over time while the oven is operating. Ecolytic Clean runs hotter to speed that up. 2 Ventilate the kitchen, wipe out big spills first using hot sudsy water on a soft cloth, and keep the vents clear. Wipe the cavity with a damp cloth afterward and dry it. 12 Do not clean parts or accessories with this function. 2

What about Easy Clean and the cleaning agents?#

Easy Clean soaks food soil with steam. Pour 14 fl. oz (400 ml) of water with 1 drop of detergent into the cooled cavity, then run Easy Clean and clean up afterward. Never use steel wool or chlorine cleaners. 2

After Easy Clean, remove leftover water with a sponge cloth, clean smooth surfaces with a dish cloth or soft brush, wipe limescale with vinegar and rinse, leave the door ajar for about an hour or use the Drying function. 2 The manual forbids steel wool, abrasive pads and cellulose sponges, since some sponges are processed with salt that can corrode the metal. 2 For heavy soil an all-purpose cleaner may be sprayed on for 15 to 30 minutes, but then run the steam clean cycle so the cavity rinses thoroughly, because residue can bond to the door glass and alter the flavor of food. 2

Which steam oven symptoms need a technician?#

Descaling that stops midway, water left on the cavity floor after correct tank use, rust spots that return, or a failed LED lamp or cover, which cannot be removed. 2

For those, ask us to send someone. Thermador keeps repairs covered by its own warranty. We state the price beforehand and settle it after the diagnosis. The oven service page explains the visit.

Sources#

  1. Cleaning & Care | Steam Ovens Support | ThermadorThermador (thermador.com, US support site) · Page undated; retrieved 12.11.2026 · Entries on descaling, limescale and Ecolytic Cleaning
  2. Use and care GUIDE: Masterpiece Series Single Steam Oven and Double Steam Oven MEDS301BS MEDS302BSThermador (BSH Home Appliances), en-us edition · File tag 8001252113_A · PDF pages 9 (water tank warning), 19 (water hardness), 26 (water tank), 44-47 (cleaning and maintenance)

Here to help

Good questions.
Clear answers.

Talk to our team
How long does the Descaling program take on a Thermador steam oven?

About 70 to 90 minutes in total, according to the Masterpiece steam oven manual, because the program has a descaling stage and two rinse cycles, and it must run completely before the oven is ready to use again. [2]

Can I put the water tank in the dishwasher?

No. The manual says the tank is not dishwasher safe and that dishwasher cleaning will damage it. Clean it with a soft cloth and standard washing-up liquid, then dry it with the lid open. [2]

Can I fill the tank with distilled water?

No. Use fresh tap water or plain non-carbonated purchased water. Where the supply is very hard, 10 grains per gallon or higher, Thermador recommends softened water instead. [2]

The cavity has red patches. Is that rust?

The manual says reddish patches that form during operation or cleaning are food residue, not rust, and are not harmful. Rust can still develop if the cavity is not cared for after each use. [2]

How often should I run Ecolytic Clean?

When the oven recommends it, or when dark patches appear on the self-cleaning surfaces. The manual says to run it as often as needed; the cycle takes 1 hour and cannot be changed. [1][2]

Let’s take care of it.

One burner, two burners,
or the whole range.