Inside the appliance
Freezer ice cube container. In plain English.
The ice maker in a Thermador T18IF905SP freezer column drops cubes into an ice cube container that sits in the frozen food container. Production begins after the freezer hits its set temperature and halts on its own when the container fills. Bottles or food stored in the container can block and damage the ice maker.

Where it fits.
Freezer ice cube container in the appliance
In the recess of the frozen food container, behind the door, with the ice maker above it.
The picture stands for a type of component. Which replacement suits your model is a separate question.
What shifts when this system needs a look.
Freezer ice cube container concerns may show up next to a drop in performance or a message that keeps returning. Testing comes before any verdict on the component.

Thermador freezer not cooling
A Thermador column freezer with a lit display that is not cooling is probably in demo mode; hold ALARM OFF for 15 seconds to end it. If it is cooling but warm, the guide points to covered ventilation openings, frequent door opening or a large load of fresh food, and suggests a 5-minute power-off reset.

Thermador freezer alarm sounding
A Thermador column freezer sounds two different alarms. If ALARM OFF flashes with a tone and the door is open, close it. If the freezer temperature display flashes too, press ALARM OFF, then check after several hours that the set temperature returns. Covered vents or a big load of fresh food are the usual causes.
Owner care, within the model instructions.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Seat the container fully
The guide lists a container that is not properly inserted as a cause when the ice maker stops. Lift it out at the rear and set it back in its recess.
- 2
Check production is on
Ice cube production can be switched off in the settings, and a warm freezer compartment also stops it.
- 3
Keep it for ice only
Never store bottles or food in the container, even briefly. Leave the ice shovel out of the bin so the level sensor reads true.
- 4
Discard the first batch
Throw out the cubes made in the first day, and the first 30 to 40 after production sat off for several days.
Cleaning or replacement?
Leave internal testing to a technician.
Production stays off with water on, the container seated and the freezer cold.
Water leaks from the freezer, or cubes stay few and misshapen for days.
Arrange a diagnosticSources and model boundaries.
These documents back up the Freezer ice cube container guidance. Choose the manual written for your model.
- Use & Care Guide, Freezer Column T18IF905SP
Match your model to the guide it shipped with. See how we research these pages.
How long does an empty container take to fill?
About a day, according to the troubleshooting table.
Why did production stop with the bin not full?
An ice shovel left on the ice can stop the sensor reading the real fill level, the guide says.
Is the first ice fine to use?
No. The guide has you discard the first day's cubes, and the first 30 to 40 after a long pause.
What should I do after an outage?
Empty the container if the freezer is switched off for long or the power fails, per the guide.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
Thermador freezer not cooling
A Thermador column freezer with a lit display that is not cooling is probably in demo mode; hold ALARM OFF for 15 seconds to end it. If it is cooling but warm, the guide points to covered ventilation openings, frequent door opening or a large load of fresh food, and suggests a 5-minute power-off reset.
Freezer repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.

