What it means
E11 on a Thermador microwave or speed oven means the touch buttons are not working properly, possibly from condensation on the keypad. Wipe the panel dry and switch the fuse off for 10 seconds.
Thermador microwave E11 / Controls
E11 on a Thermador microwave or speed oven means the touch buttons are not working properly, possibly from condensation on the keypad. Wipe the panel dry and switch the fuse off for 10 seconds.
Also appears as E11
E11 on a Thermador microwave or speed oven means the touch buttons are not working properly, possibly from condensation on the keypad. Wipe the panel dry and switch the fuse off for 10 seconds.
Wipe the control panel with a dry cloth.
E11 returns after the reset.
Your Thermador steps, stored on this device only

Wipe the control panel with a dry cloth.

Switch the fuse off in the fuse box.

Then switch it back on.
If the buttons still misbehave, the guide suggests a technician check the grounding.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
The Thermador manual names condensation on the keypad as a possible cause.
Read the supporting manualIt has a cleaning step, which the general E number entry lacks.
Read the supporting manualThe speed oven guide lists "touch buttons do not operate properly" with the same fuse step.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry "E11 and a phone number"
Sources: the error-code page for Thermador microwaves and speed ovens, entry E11, and the speed oven troubleshooting table.
No, use a dry cloth, as Thermador says. Condensation on the keypad is the possible cause, so the panel should end up dry.
The Thermador manual says it may be due to it.
Keep the fuse off for 10 seconds, then switch it back on after wiping the panel dry.
The oven E11 entry has the same source.
Thermador messages, symptoms, parts, repair visits
An E followed by digits on a Thermador microwave or speed oven means a malfunction occurred. Note the code, then switch the appliance off at the fuse box.
When a Thermador built-in microwave’s display works but the oven will not run, the guide asks you to confirm the door is shut with nothing caught in the seal, the door is undamaged and demo mode is off. A fully dead display points to the breaker, fuse or plug.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.