What it means
An E followed by digits on a Thermador microwave or speed oven means a malfunction occurred. Note the code, then switch the appliance off at the fuse box.
Thermador microwave E and a number / Controls
An E followed by digits on a Thermador microwave or speed oven means a malfunction occurred. Note the code, then switch the appliance off at the fuse box.
Also appears as E and a number
An E followed by digits on a Thermador microwave or speed oven means a malfunction occurred. Note the code, then switch the appliance off at the fuse box.
Copy the E and every digit exactly as shown.
The E number returns after the fuse reset.
Your Thermador steps, stored on this device only

Copy the E and every digit exactly as shown.

Disconnect the appliance by switching off its fuse in the fuse box.

Switch the fuse back on after a pause and see whether the code returns.
A returning E number needs a technician; give us the digits.
Give us your model number and the checks you already made, then start your request below.
Book a visitA simplified drawing, since the layout shifts from one model to the next. Tap any outlined part for its photo and the check that goes with it.
Only that a malfunction occurred. The Thermador manual does not decode individual numbers.
Read the supporting manualE11, a keypad message with a cleaning step.
Read the supporting manualThe manual asks you to note any codes that appear, because support needs the exact number.
Read the supporting manualManufacturer document
Thermador / BSH Home Appliances (thermador.com/us support page)
Undated web page; fetched 12.11.2026 / entry ""E" and a number appears on the display with a phone number"
Source: the error-code page for Thermador microwaves and speed ovens, entry E and a number.
The Thermador manual does not rank them. An E and digits means only that a malfunction occurred, so note the exact code and cut power at the fuse box.
The Thermador manual advises disconnecting power at the fuse box, so note the code and see whether it returns after the reset before you use the appliance again.
The Thermador manual gives 10 seconds for E11; for other E numbers it gives no time, so switch the fuse back on after a pause and see whether the code returns.
The exact digits shown and your model. The Thermador manual asks you to note any codes, because support needs the exact number.
Thermador messages, symptoms, parts, repair visits
E11 on a Thermador microwave or speed oven means the touch buttons are not working properly, possibly from condensation on the keypad. Wipe the panel dry and switch the fuse off for 10 seconds.
When a Thermador built-in microwave’s display works but the oven will not run, the guide asks you to confirm the door is shut with nothing caught in the seal, the door is undamaged and demo mode is off. A fully dead display points to the breaker, fuse or plug.
Book a diagnostic made for your exact model and performed at the appliance itself.
Where the offices are, and what to tell us about getting in.