Start from the symptom
Thermador wine column wine reserve HI alarm.
HI on the display of a Thermador wine reserve means the high temperature alarm has triggered. The guide gives four causes: frequent door opening, covered vents, a large load of warm bottles and a hot room or bad gasket. Fix the cause, then press alarm once to silence it.

Start with safe observations.
Turn the appliance off and pull the plug before doing any check yourself. Look out for standing water and sharp edges. Never handle a wet plug, remove a service panel or step beyond what your model's guide permits an owner.
- 1
Door use
If the door was opened often, stop opening it and press alarm once to deactivate the alarm.
- 2
Vents
Remove obstacles at the ventilation openings at the base of the unit and in the interior, then press alarm once.
- 3
Warm bottles
Wait until the products cool off or take the warm bottles out, then press alarm once.
- 4
Environment
Avoid sunlight and heat sources near the unit, then press alarm.
- 5
Gasket
Inspect the door gasket. A damaged gasket lets cold air out and the temperature rises. Press alarm once to deactivate.
Systems a technician may investigate.
These parts relate to the symptom, though what you noticed cannot show that any single one has failed.
Look after it the way this appliance's own guide describes.
When observation becomes a service request.
Leave internal testing to a technician.
HI returns after the cause was removed and the alarm pressed.
The gasket is damaged.
The temperature will not drop after warm bottles are removed.
The unit shows OFF and will not switch on.
Arrange a diagnosticSources and model boundaries.
These documents back up the Thermador wine reserve HI alarm guidance. Choose the manual written for your model.
- Use & Care Guide, Glass Door Wine Reserve T24UW925LS T24UW925RS T24UW915LS T24UW915RS T24UW905LP T24UW905RP
Match your model to the guide it shipped with. See how we research these pages.
What does HI mean?
The Hi-alarm is activated because the temperature inside the appliance is high. HI shows on the display LED.
How do I stop the beeping?
Press alarm once to deactivate, after you remove the cause.
Will adding many bottles set it off?
Yes. A large amount of product, or warm product, is a listed cause.
Does sunlight matter?
Yes. The guide says to avoid placing the unit in direct sunlight or near a heat source.
Thermador messages, symptoms, parts, repair visits
Move from the message to your next step.
HI
HI on a Thermador under-counter wine cooler means the temperature inside is too high. Wait for the contents to cool or remove warm bottles, then press the alarm button once.
Thermador wine reserve not cooling
A Thermador glass door wine reserve that is not cooling may simply be switched off: if the display reads OFF, hold the ON/OFF button for 3 seconds. Otherwise the guide names heavy door use, covered vents, a warm room and a damaged gasket. Go through those, and call us if bottles stay warm.
Wine reserve temperature zones
A Thermador glass door wine reserve is split in two: a top compartment and a bottom compartment, each set separately. The guide starts the upper at 46 degrees F and the lower at 58, with ranges of 40 to 54 and 40 to 64. The left buttons change the upper zone and the right buttons the lower.
Wine column repair
Book a diagnostic made for your exact model and performed at the appliance itself.
Find your metro
Where the offices are, and what to tell us about getting in.
